Skip to main content
06 60 98 96 98

Underfloor heating

The underfloor heating described here spreads heat through a hot-water circuit laid in the slab or the screed. It is planned in a new build, or in a renovation when the floor can still gain thickness. Without that height, it is not promised.

AEROVENTIS connects it to the heat source, often an air-to-water heat pump, and to the plumbing. Casablanca, Rabat, Marrakech, Mohammedia, Bouskoura, Tamaris and Zenata do not share the same heating season or the same floors. The visit decides.

Underfloor heating install: pipe loops on a slab, before the screed.
  • Underfloor heating loops in a tiled room, before the screed.
  • Underfloor heating connected to a manifold set into the wall.
  • Underfloor heating manifold, with insulated outlets running down to the slab.

Services

Three parts. Each one is drawn before the floor is poured.

Loops

Pipes in the floor, room by room, with a spacing taken from the survey.

Manifolds

They separate the rooms. They sit in a cupboard or a plant space that stays reachable.

Heat source

The heat pump, or another source already planned, feeds the circuit. It is chosen on its own.

Decided on site

What is checked before the floor is fixed.

New build

The loops go in before the screed. Coming back after the finishes means opening the floor.

Renovation

The spare height, the insulation and the planned finish are measured. If the margin is missing, another emitter is the honest answer.

Rooms

A bathroom and a living room do not need the same heat. Loops are separated rather than set with one control.

How it proceeds

The floor closes quickly. The order of the trades matters as much as the layout.

  1. 1. Site visit

    See the floor build-up, the rooms to heat and the place for the manifolds.

  2. 2. Study

    Draw the loops and the link to the heat source.

  3. 3. Installation and commissioning

    Install before the screed, fill the circuit and check that it holds.

  4. 4. Maintenance

    Leave the manifolds reachable for a later setting or check.

Common questions

What is this underfloor heating made of?

A hot-water circuit in the slab or the screed, connected to a heat source. This page describes that water network.

Is an air-to-water heat pump required?

It often feeds the floor. Another source may already be there. It is not assumed: it is seen, or it is planned with the heat-pump page.

Can it be installed in a renovation?

Only if the floor can still take the insulation, the pipes and the screed without blocking the doors. Otherwise that is said after the survey.

How does it relate to plumbing?

Manifolds, supply and venting are part of the water network. The home's plumbing is looked at at the same time.

Which areas are covered?

Casablanca, Mohammedia, Bouskoura, Tamaris, Zenata, Rabat and Marrakech. The coast and Marrakech do not share the same heating season. The survey stays local.

How do I ask for a visit?

Give the city and whether the floor is still open. A technician arranges a visit before the screed. You can also write on WhatsApp.

Talk about the project

Tell us the city, the district and the type of home. A technician arranges a visit to see the place.

Hydronic underfloor heating | AEROVENTIS