Skip to main content
06 60 98 96 98

Technical installation of a beldi hammam

This page describes the technical installation of a beldi hammam: heating, steam and plumbing. It does not describe tiling, plaster or decoration.

The room needs hot water, steam and a drain that actually leaves. AEROVENTIS looks at the room, the water supply and the outlet, for villas and houses in Casablanca, Mohammedia, Bouskoura, Tamaris, Zenata, Rabat and Marrakech.

Hammam heating circuit: copper on the floor, the bench and the wall.
  • Copper network of a hammam, fixed on the benches, the floor and the walls.
  • Copper pipes on a hammam bench, before the finish.
  • Copper coil fixed on a hammam bench and wall.

Services

Three networks. The real volume of the room sizes them.

Heating

Raising the temperature of the room and of the water, from the volume that was seen, not from one standard model.

Steam

Producing and spreading steam, with room for the appliance and for its maintenance.

Plumbing

Supply, drainage and falls. Water should not sit, and it should not enter a pipe that cannot take it.

Decided on site

What is seen before an appliance is fixed.

The room

Volume, height, access and neighbours. A hammam in a villa is not treated like a room in the middle of a building.

The water

The supply and the outlet are seen before the choice. A drain that is too high or too far changes the project.

Humid air

Steam is a heating subject. Extracting very humid air is another network: they are coordinated, not confused.

How it proceeds

A hammam is decided in the room, not from a drawing copied from another job.

  1. 1. Site visit

    See the room, the water available and the place of the outlet.

  2. 2. Study

    Choose the heating, the steam production and the pipe sizes from that survey.

  3. 3. Installation and commissioning

    Install, fill and check that steam and drainage stay in the room that was planned.

  4. 4. Maintenance

    Leave appliances and valves reachable, away from where people sit.

Common questions

Is the hammam decoration included?

No. Tiling, plaster and decoration are not part of this page. The installation covers heating, steam and plumbing.

Where does the heat come from?

From an appliance chosen for the volume, sometimes connected to an air-to-water heat pump when the project allows it. It is not decided without seeing the room.

Is air extraction needed?

Very humid air is not treated as steam. Extraction is a separate network. Both are looked at together so the humidity stays in the hammam.

Are a villa and a building the same job?

No. A building adds shared stacks, the building rules and humidity reaching a neighbour. A villa adds longer pipe runs.

Which areas are covered?

Casablanca, Mohammedia, Bouskoura, Tamaris, Zenata, Rabat and Marrakech. The visit is to see the room, not to work from a plan alone.

How do I ask for a visit?

Describe the city and the planned room on the contact page, or write on WhatsApp. A technician then arranges a visit.

Talk about the project

Tell us the city, the district and the type of home. A technician arranges a visit to see the place.

Beldi hammam installation | AEROVENTIS